How To Install Direct Wire Led Tubes
How To Install Direct Wire Led Tubes. Direct wiring circuit diagram of a retrofitted. To do a direct wire, you choose your hot side, and eliminate ballast wires from socket, then run hot and neutral to said socket.
2) remove or short ballast and starter if present. Below is the spec data for the direct wire t8 led tube light for t8 t12 fluorescent replacement, which is bypassing with your existing ballast, require rewiring in the fluorescent fittings. It is type b in dlc listing category, below is the wiring diagram instruction for this t8 light bulbs.
Install New Energy Focus Led Tube;
Led tube lamp only requires power at one end. Lamp holder sockets do not need to be replaced unless damaged or missing. Connect the hot (red, black, or blue) and neutral (white) wires to the tombstone wires and make a ‘series’ connection.
The Instruction Manuals That Come With The Fittings And Tubes Don't Seem To Have Much Info, But I've Tried To Narrow It Down To A Few Possible Problems.
If not qualified, do not attempt installation. Click to find more info about led tube lights. If you have configuration “c” (single wire coming from the g13 socket at the end of each tube) go to step 3.
Direct Wire (Ballast Bypass) Led Tubes.
Install led tube(s), matching the end of the lamp that has the “l/n” sticker to the lamp holder that is connected to the live and neutral wires. Below is the spec data for the direct wire t8 led tube light for t8 t12 fluorescent replacement, which is bypassing with your existing ballast, require rewiring in the fluorescent fittings. All the wires are now assembled into the connector on the neutral side.
Contact A Qualified Electrician For Installation.
Direct wiring circuit diagram of a retrofitted. If the luminaire is modified for led tube use and has label, the new label may be discarded. Direct wire/ballast bypass led tubes
Always Turn The Power Off To The Light Fixture When Installing Or Replacing Tubes In Direct Wired Fixtures.
To do a direct wire, you choose your hot side, and eliminate ballast wires from socket, then run hot and neutral to said socket. Cut the wires leading to the ballast; Install the bracket and the lamp;
Post a Comment for "How To Install Direct Wire Led Tubes"